Saturday, October 16, 2021

Erase Configuration Brocade CES 2024C: Awas Salah Pilih Menu!

JKT-CES-JKT-2#erase ?
flash                  Code flash (Jangan pilih ini, karena nanti Brocade-nya gak bisa Loading karena harus di-flash ulang)
startup-config  Startup config (Pilih ini jika ingin menghapus seluruh konfigurasi dan kembali ke menjadi settingan default)

JKT-CES-JKT-2#erase startup-config 
Erase startup-config Done
JKT-CES-JKT-2#reload
Checking for coherence...

Image coherence check: Can't open startup config file.
Warning: Image coherence check skipped due to insufficient info: MP/LP not booting from flash.
Are you sure? (enter 'y' or 'n'): y
Halt and reboot

NetIron CE 2000 Boot Code Version 5.5.0 
Enter 'a' to stop at memory test
Enter 'b' to stop at boot monitor
BOOT INFO: load monitor from code flash, cksum = 561c
BOOT INFO: verify flash files - max_code_flash_blocks[126].....
BOOT INFO: load image from primary copy........

Metro 24X1G Copper is detected.
.
.
.
NetIron CES 2024C#show version 
System: NetIron CES (Serial #: D42534J0N2,  Part #: 35701-004)
License: ME_PREM (LID: fJHKIJlFpH)
Boot     : Version 5.5.0T185 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Oct  9 2012 at 15:42:18 labeled as ceb05500
 (456370 bytes) from boot flash
Monitor  : Version 5.5.0T185 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Oct  9 2012 at 15:42:18 labeled as ceb05500
 (456370 bytes) from code flash
IronWare : Version 5.5.0dT183 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Oct  3 2013 at 13:52:26 labeled as ce05500d
 (16506381 bytes) from Primary
CPLD Version: 0x00000010
Micro-Controller Version: 0x0000000d
PBIF Version: 0x0159
800 MHz Power PC processor 8544 (version 8021/0023) 400 MHz bus
512 KB Boot Flash (MX29LV040C), 32 MB Code Flash (MT28F128J3)
512 MB DRAM
System uptime is 3 minutes 18 seconds 

NetIron CES 2024C#show run
Current configuration:
!
ver V5.5.0dT183
!
!
!
!

!
no spanning-tree
!
!
vlan 1 name DEFAULT-VLAN 

Config New ONT ZTE di OLT GPON Nokia (isam-release : R5.6.02c) : Mode QinQ Vlan Transparent

Configuration
leg:isadmin>#configure qos profiles bandwidth DOWN-33M committed-info-rate 0 assured-info-rate 0 excessive-info-rate 33000
leg:isadmin>#configure qos profiles shaper DOWN-33M committed-info-rate 0 committed-burst-size 0 excess-info-rate 33000 type singletokenbucketgpon
leg:isadmin>#configure qos profiles bandwidth UP-33M committed-info-rate 0 assured-info-rate 0 excessive-info-rate 33000 

leg:isadmin>#configure equipment ont interface 1/1/1/2/10 sernum ZTEG:C11948FD sw-ver-pland disabled (SN ONT ZTE dipisah dengan ":")
leg:isadmin>#configure>equipment>ont>interface>1/1/1/2/10$ desc1 Internet_Dedicated_30Mbps
leg:isadmin>#configure>equipment>ont>interface>1/1/1/2/10$ admin-state up
leg:isadmin>#configure equipment ont slot 1/1/1/2/10/1 plndnumdataports 4 plndnumvoiceports 0 planned-card-type ethernet
leg:isadmin>#configure interface port uni:1/1/1/2/10/1/1 admin-up (Port yang UP Port 1)
leg:isadmin>#configure qos interface 1/1/1/2/10/1/1 upstream-queue 0
leg:isadmin>#configure qos interface 1/1/1/2/10/1/1 queue 0 shaper-profile name:DOWN-33M
leg:isadmin>#configure qos interface 1/1/1/2/10/1/1 upstream-queue 0 bandwidth-profile name:UP-33M

leg:isadmin>#configure vlan id stacked:1402:0 mode residential-bridge
leg:isadmin>#configure>vlan>id>1031$ in-qos-prof-name name:Default_TC0

leg:isadmin>#configure bridge port nt:xfp:1 vlan-id stacked:1402:0 (Tag vlan ke arah Port Uplink)
leg:isadmin>#configure bridge port 1/1/1/2/10/1/1 max-unicast-mac 100
leg:isadmin>#configure bridge port 1/1/1/2/10/1/1 vlan-id 1031 tag single-tagged l2fwder-vlan stacked:1402:0 vlan-scope local (Tag vlan ke arah ont port 1)
leg:isadmin>#configure bridge port 1/1/1/2/10/1/1 pvid 1031

configure interface port vlan-port:1/1/1/2/10/1/1:1031
leg:isadmin>#configure>interface>port>vlan-port:1/1/1/2/10/1/1:1031# admin-up 

configure qos interface vlan:1/1/1/2/10/1/1:1031

Checking After Config
leg:alcatel-lucent-nokia-R5.6.02c:administrator>#info configure qos profiles bandwidth 
configure qos profiles
#---------------------------------------------------------------------------------------------------------------------------
echo "qos"
#---------------------------------------------------------------------------------------------------------------------------
bandwidth UP-50M committed-info-rate 0 assured-info-rate 0 excessive-info-rate 51200
exit
bandwidth DOWN-50M committed-info-rate 0 assured-info-rate 0 excessive-info-rate 51200
exit

leg:alcatel-lucent-nokia-R5.6.02c:administrator>#info configure equipment ont interface 1/1/1/1/5
configure equipment ont
#---------------------------------------------------------------------------------------------------------------------------
echo "equipment"
#---------------------------------------------------------------------------------------------------------------------------
interface 1/1/1/1/5 sw-ver-pland disabled
  desc1 "Customer ATM Bank Dunia"
  sernum HWTC:95670680
  subslocid WILDCARD
  fec-up disable
  sw-dnload-version disabled
  log-auth-pwd plain:******
  admin-state up
exit
#

Untuk Pengecekan dibawah ini dilakukan dengan mencari secara manual dengan "Info Configgure" (show run)
#---------------------------------------------------------------------------------------------------------------------------
echo "qos"
#---------------------------------------------------------------------------------------------------------------------------
qos
  interface vlan:1/1/1/1/5/1/1:stacked:1063:0
    ds-num-queue not-applicable
    ds-num-rem-queue not-applicable
    us-num-queue not-applicable
    oper-weight 0
    oper-rate 0
    gem-sharing not-applicable
    mc-scheduler-node none
    bc-scheduler-node none
  exit

  interface 1/1/1/1/5/1/1
    scheduler-node name:NGLT_Default
    cac-profile name:FD_ONTUniVideo
    ds-num-rem-queue not-applicable
    us-num-queue not-applicable
    oper-weight 50
    oper-rate 0
    mc-scheduler-node none
    bc-scheduler-node none
    queue 0
      priority 6
      weight 34
      oper-weight 34
      queue-profile name:NGLT_Default
      shaper-profile name:DOWN-50M
    exit

#---------------------------------------------------------------------------------------------------------------------------
echo "vlan"
#---------------------------------------------------------------------------------------------------------------------------
vlan
  broadcast-frames
  priority-policy port-default
  vmac-address-format
    host-id 0
  exit
  id stacked:1063:0 mode residential-bridge
    name QinQ_ATM-BANK-DUNIA
    in-qos-prof-name name:Default_TC0  exit
  exit

#---------------------------------------------------------------------------------------------------------------------------
echo "bridge"
#---------------------------------------------------------------------------------------------------------------------------
bridge
  port nt:xfp:1
    max-unicast-mac 2000
    vlan-id 1063
      l2fwder-vlan stacked:1063:0
      vlan-scope local
    exit
  port 1/1/1/1/5/1/1
    max-unicast-mac 100
    vlan-id stacked:1063:0
    exit
    pvid stacked:1063:0
  exit
  
#---------------------------------------------------------------------------------------------------------------------------
echo "interface"
#---------------------------------------------------------------------------------------------------------------------------
interface
  port uni:1/1/1/1/5/1/1
    admin-up
  exit
  port vlan-port:1/1/1/1/5/1/1:stacked:1063:0
    admin-up
    severity no-value
  exit

Temukan Artikel lainnya tentang GPON OLT dan FTTH di --> List All Articles About GPON OLT Huawei - ZTE - Alcatel Lucent in This Blog [Updated]